Electrons In Oxygen

• Electrons In Oxygen -2
• Electrons In Oxygen And Neutrons
• Electrons In Oxygen
• Electrons In Oxygen 17
• Electrons In Oxygen Atom
• Electrons In Oxygen 16
• Electrons In Oxygen 17

Chemicals (such as oxygen) that accept electrons from other compounds are called oxidizing agents, and substances (such as methane or hydrogen) that give up electrons are called reducing agents. The degree to which a fluid is oxidizing or reducing (represented by ORP) depends on the presence and strength of various oxidizing and reducing agents. The number in your question e.g. Oxygen 17, Cobalt 60 is the isotope number which gives the total number of nucleons. Now a proton is positively charged so in an electrically neutral atom the total number of electrons must be the same as the total number of protons.

Quantum Numbers: H to Ne

There are four quantum numbers: n, ℓ, m_ℓ, and m_s. Each one is a particular factor in an equation describing a property of the electron. At this introductory level, the equations are not needed. The value of each quantum number is assigned to each electron in an atom by a 'building up' process. Niels Bohr called this process the 'Aufbau' principle: aufbau means 'building up.'

n is ALWAYS the starting point for building up a series of quantum numbers. Each quantum number is then assigned according to a set of rules, each of which took years of study to finally determine. The rules ARE NOT just any old arbitrary ones; they have been determined from a study of nature. Remember the rules:

(1) n = 1, 2, 3, and so on.
(2) ℓ = 0, 1, 2, . . . , n - 1
(3) m_ℓ starts at negative ℓ, runs by whole numbers to zero and then goes to positive ℓ.
(4) after the n, ℓ and m_ℓ to be used have been determined, assign the m_s value +½ to one electron, then assign the m_s value of -½ to the next electron, while using the same n, ℓ and m values.

Also, keep in mind that we use only one n, ℓ, m_ℓ, and m_s value each to make a set of four quantum numbers for each electron. It is this set of four quantum numbers that uniquely identifies each electron.

Last point: the last column in each table below is called 'Orbital Name.' As you are reading this tutorial, you may not yet know what an orbital is. That's OK, but please understand the concept called 'orbital' is an important one. Here's a real simple description that ignores lots of details: each orbital is a region of space around the nucleus which contains a MAXIMUM of two electrons. Realize that it's more complex than that, but the above description is good enough for now. I hope!!

Hydrogen - one electron

First Electron

n = 1
ℓ = 0
m_ℓ = 0

In each case, note that we start with the smallest value of n, ℓ, or m_ℓ possible. Make sure you look over the rules to see how each value was arrived at. ℓ starts at zero and goes to n - 1, which is zero since we get 1 - 1 = 0, when using n = 1. When ℓ = 0, there is only one possible choice for m_ℓ, which must be zero.

m_s = +½

This completes the four quantum numbers for the single electron possessed by hydrogen. I shall build up a table like this:

Helium - two electrons

First Electron

n = 1
ℓ = 0
m_ℓ = 0
m_s = +½

The first electron in helium has exactly the same four quantum number of the first electron in hydrogen. However, helium has TWO electrons. So we 'build up' from the previous electrons by adding one more.

Second Electron

n = 1
ℓ = 0
m_ℓ = 0
m_s = -½

Notice the same n, ℓ, and m_ℓ values, but m_s has shifted from positive ½ to negative ½. This was the problem Pauli saw in 1925. Three quantum numbers was insufficient to UNIQUELY identify each electron, but a fourth one (the one called m_s) did the trick.

Lithium - three electrons

The first two electrons quantum numbers' are EXACTLY the same as the two in helium:

1, 0, 0, +½ and 1, 0, 0, -½

Third Electron: here's where we 'build up' by adding one more electron.

However, we are now presented with a problem. All the values with n = 1 have been used up, but we have only accounted for two of lithium's three electrons. What to do about the third?

Answer: start with the NEXT n value; n = 2. However, there is a problem with ℓ; do we use ℓ = 0 or ℓ = 1, since both are possible with n = 2?

Answer: start with the lowest value first, so that means using ℓ = 0. (Don't worry, we will use ℓ = 1 soon enough.)

Figuring out m_ℓ should be easy; when ℓ = 0, m_ℓ can only equal 0. So n, ℓ, m_ℓ for the third electron is 2, 0, 0. I'll add in m_s in the table below.

Electrons In Oxygen -2

Beryllium - four electrons

In the building up process, we go one electron at a time. Therefore, we will use the three from lithium and add one more.

Fourth Electron

n = 2
ℓ = 0
m_ℓ = 0
m_s = -½

Notice the same n, ℓ, and m values as the third electron, but m_s for the fourth electron has shifted from positive ½ to negative ½.

Pretty easy, eh? It stays easy, if you follow the rules. With beryllium, we have exhausted the possibilities for the n = 2; ℓ = 0 combination. However, when n = 2, ℓ can take on another value, namely ℓ = 1. This has consequences for the m_ℓ value as well and, after we finish, there will be six electrons that have a combination of n = 2 and ℓ = 1.

Here's the rule for m_ℓ again: start at negative ℓ, run by whole numbers to zero and then go to positive ℓ. Since ℓ = 1, we start with -1, go to zero and end up at +1. This gives us three values for m_ℓ when ℓ = 1. Hopefully you can see that, since m_s takes on +½ and -½, we will wind up with six sets of quantum numbers.

Electrons In Oxygen And Neutrons

Warning: there's going to be a new rule introduced after boron. So prepare yourself because, just as you thought it was getting easy, there gets added some new stuff. By the way, us mean old teachers didn't make all this stuff up to torture poor chemistry students. Nature really does do what I will explain below. Here's boron:

Boron - five electrons

Following the usual pattern, I've repeated the previous four electrons. As we go on to the ℓ = 1 values, keep in mind that we will start with the lowest value of m_ℓ, namely negative one.

Eventually, I will wind up with three orbital names. 2p_x is just the first, x meaning the x-axis. Next will be 2p_y, for the y-axis and the last name used will be 2p_z, for the z-axis. These three orbitals are oriented at 90° to each other.

Hund's Rule (named for Fredrich Hund) is the name of the new rule. This rule concerns the relationship between the ℓ and m_ℓ quantum numbers. When ℓ = 0, m_ℓ can only equal zero and Hund's Rule does not show up. However, now that we have reached ℓ = 1, m_ℓ can take on multiple values. Hund's Rule concerns the order in which we assign the ℓ and m_ℓ values.

By the way, I'm going to avoid a technical statement of Hund's Rule for the moment. I'll discuss how it works first.

Electrons In Oxygen

Hund's Rule means that we will use each possible ℓ, m_ℓ combination ONCE before going back and using it a second time. Here are the three possible ℓ, m_ℓ combos when ℓ = 1:

For boron, we have used the ℓ, m_ℓ combination of 1, -1. The key is to see that Hund's Rule requires we go on to the NEXT ℓ, m_ℓ combination for the next element: carbon.

Carbon - six electrons

Following the usual pattern, I've repeated the previous five electrons. As we continue on with the ℓ = 1 values, keep in mind that Hund's Rule will affect how we assign the next m_ℓ value.

Nitrogen - seven electrons

Since we still have not first used all possible ℓ, m_ℓ values ONCE, we go on to the next ℓ, m_ℓ combination.

2p_x, 2p_y and 2p_z are three different orbitals, each one capable of holding two electrons. Notice how, in nitrogen, each of the three orbitals is filled up HALF-WAY (that is, with one electron) before we go back and fill up each orbital with the second electron.

Electrons In Oxygen 17

This 'half-filled orbital' has definite chemical consequences. Remember it well. Also, using 2p_x first, then going to y and then z is purely convention. The x, y, z order is not of consequence in the above examples. However keep in mind the using each letter ONCE first being using it for the second electron is important.

Electrons In Oxygen Atom

Oxygen - eight electrons

Now that we have used each ℓ, m_ℓ combination once, we proceed to go back and use each combo the second time. For oxygen to neon, I've marked which electron is the one added.

Fluorine - nine electrons

Neon - ten electrons

We have now completed all possible values for n = 1 AND n = 2. Starting with element 11, sodium, we will proceed on to n = 3. When we finish, we will have used ℓ = 0, ℓ = 1 (and applied Hund's Rule again) and then, before going on to ℓ = 3, we will hit another interesting twist that nature has handed us. We will wind up going on to n = 4 and then coming back to finish n = 3. It will be fun!

Here we are going to help you guys with one of the subjects which are not very difficult but if the topic is not clear then the students will be stuck and find problems in solving the solutions related to such topics.

Electrons In Oxygen 16

Oxygen Valence Electrons

Electrons In Oxygen 17

What is the Valence of Oxygen in Water?

Periodic Table Charges of Elements

Oxygen Electron Configuration